Table of Contents
Advertisement
8
Troubleshooting and tips
V
CAUTION!
Follow the safety instructions in the "Safety notes and regulations"
manual or " 安全上のご注意 " and in chapter
page
23.
If a fault occurs, attempt to resolve it using the measures described:
– in this chapter,
– in the documentation for the connected devices,
– in the help systems of the software used.
8.1
Power-on indicator remains unlit
The power-on indicator remains dark after you switch on your device.
Power cable incorrectly connected
Ê Make sure that the power cable(s) is/are correctly connected to the server
node and the grounded power outlet(s).
Power supply overloaded
Ê Disconnect the server node power plug(s) from the grounded power
outlet(s).
Ê Wait a few minutes before you plug it/them into the grounded power outlet(s)
again.
Ê Switch on your server node.
8.2
Server node switches itself off
Server Management has detected an error
Ê Check the error list of System Event Log in ServerView Operations Manager
or in the BMC web interface, and attempt to eliminate the error.
CX270 S1
Operating Manual
"Important information" on
55
Advertisement
Table of Contents
