Jogging (Jg) - Omron MX2 Series User Manual

5-9-6

Jogging (JG)

• When the jogging function is enabled, jogging operation starts when the RUN command is input.
• To enable the jogging function, set the Multi-function Input 1 to 7 Selection (C001 to C007) to 06
(JG: Jogging).
• Then, set the frequency reference for jogging operation in the Jogging Frequency (A038).
Because, in jogging operation, the frequency reference is output without acceleration time, setting a
high jogging frequency value may cause an overload or trip error. Be sure to set a frequency value
that does not cause tripping.
• Use the Jogging Stop Selection (A039) to set the jogging stop method and whether to enable or dis-
able the jogging function during operation.
Parameter
No.
Multi-function Input 1 to 7
C001 to
C007
Selection
A038 Jogging Frequency
A039 Jogging Stop Selection
*1. In high-frequency mode.
*2. If the Jogging Stop Selection(A039) is set to 02 or 05, set the DC Injection Braking Selection (A051).
Refer to 7-9-1 DC Injection Braking (DB) on page 7-93.
⚫ Disabled during operation
When the Jogging Stop Selection (A039) is set to 00, 01, or 02, jogging operation is not performed if
the FW signal turns ON first.
To perform jogging operation, turn ON the JG terminal and then turn ON the terminal FW or RV.
Jogging Operation Enabled
Multi-function Compact Inverter 3G3MX2-EV2 User's Manual (I666-E1)
Function name
06:
0.00
Starting Frequency to 10.00 (100.00)
00:
01:
02:
03:
04:
05:
Data
JG (Jogging)
Free-running on jogging stop/Dis-
abled during operation
Deceleration stop on jogging
stop/Disabled during operation
DC injection braking on jogging
*2
stop /Disabled during operation
Free-running on jogging
stop/Enabled during operation
Deceleration stop on jogging
stop/Enabled during operation
DC injection braking on jogging
*2
stop /Enabled during operation
Jogging Operation Disabled
5 Basic Settings
Default data Unit
− −
6.00 Hz
*1
−
04
5 - 51
5