Omron MX2 Series User Manual page 81

2 Design
CAUTION
Be sure to confirm safety before conducting maintenance, inspection or parts replacement. Not
doing so might result in a minor injury.
Do not connect resistors to the terminals [+1, P/+] and the terminal [N/-] directly. Doing so might
result in a small-scale fire, heat generation or damage to the unit.
Install a stop motion device to ensure safety. Not doing so might result in a minor injury. (A holding
2
brake is not a stop motion device designed to ensure safety.)
Be sure to use a specified type of braking resistor / regenerative braking unit. In case of a braking
resistor, install a thermal relay that monitors the temperature of the resistor. Not doing so might
result in a moderate burn due to the heat generated in the braking resistor / regenerative braking
unit. Configure a sequence that enables the Inverter power to turn off when unusual overheating is
detected in the braking resistor / regenerative braking unit.
The Inverter has high voltage parts inside which, if short-circuited, might cause damage to itself or
other property. Place covers on the openings or take other precautions to make sure that no metal
objects such as cutting bits or lead wire scraps go inside when installing and wiring.
Take safety precautions such as setting up a molded-case circut breaker (MCCB) that matches the
Inverter capacity on the power supply side. Not doing so might result in damage to property due to
the short circuit of the load.
Do not dismantle, repair or modify the product.
Doing so may result in an injury.
If a parameter is set incorrectly when starting up, adjusting, maintaining, or replacing, an unex-
pected operation may occur.
If the DriveProgramming stops during multi-function output, the output status is held. Take safety
precautions such as stopping peripheral devices. Not doing so might result in a minor injury.
Multi-function Compact Inverter 3G3MX2-EV2 User's Manual (I666-E1)
2 - 3