Omron MX2 Series User Manual page 128

2 Design
⚫ Low-voltage Directive
The 3G3MX2-EV2 Series Inverter complies with EN61800-5-1 when installed and wired to equipment
according to the methods described below.
• The 3G3MX2-EV2 Series Inverter is an open type device. Be sure to install it inside the
control panel.
• The power supply and voltage (SELV) with reinforced or double insulation should be used for wir-
ing to the control circuit terminals.
• To satisfy requirements of the LVD (Low Voltage Directive), the inverter must be protected with
fuses in case a short-circuiting accident occurs. Be sure to install fuses on the power supply side
of the inverter. The fuses must be selected from the products listed in A-4 UL/cUL Standards Cau-
tions on page A-9.
• Use one set of fuses per inverter.
• Use the crimp terminal with an insulation sleeve to connect to the main circuit terminals.
• This product complies with the requirements of IEC 60364-4-41: 2005/AMD1: 2017: Clause 411
"Protective measure: automatic disconnection of supply", since it complies with the requirements
of IEC61800-5-1: 2007+AMD1: 2016: Clause 4.3.9.
For installation of inverters, wiring, and fuses for protecting the main circuit, it is necessary to com-
ply with the descriptions in Chapter 2 of this manual and A-4 UL/cUL Standards Cautions on page
A-9.
• Regarding IEC61800-5-1: Clause 5.2.3.6.3.3 "Short-circuit between phase terminals of power out-
put and protective earth", circuitry in compliance test is as described as "Figure 13 - Example of
short-circuit test between CDM/BDM d.c. link power output and protective earth" and "Class J 30A
Non time delay fuse" is used as "OCPD" in "Fault loop".
⚫ Manufacturer
OMRON Corporation
Shiokoji Horikawa, Shimogyo-ku, Kyoto 600-8530 Japan
⚫ Importer in EU
OMRON Europe B.V.
Wegalaan 67-69, 2132 JD Hoofddorp, The Netherlands
Cautions when exporting to Europe
• Not all OMRON products in Europe are imported through the above importer.
When a different importer is exporting OMRON products to Europe, those importer is responsible
to clarify their name and address as an importer and clearly indicate to the customer.
⚫ Contact in UK
The UK legislation require clear indication of the name and address of the manufacturer and
importer is compulsory. The importer must clearly indicate the importer name and address to the
customer.
(UKCA Contact)
Omron Electronics LTD.
Opal Drive, Fox Milne, MK15 0DG, Milton Keynes, United Kingdom
2 - 50
Multi-function Compact Inverter 3G3MX2-EV2 User's Manual (I666-E1)