Disconnecting Inputs From Outputs - Extron electronics DMP 128 Plus User Manual

Creating Subscriptions Between Transmitters and Receivers
1. Ensure the control computer and DMP 128 Plus AT are
connected to the same network.
2. From the start menu select:
All Programs > Audinate> Dante Controller >
Dante Controller
The Dante Controller - Network View screen opens
(see figure 36).
Dante Controller auto-discovers Dante devices on the
network and advertises itself to allow other Dante-enabled
devices to communicate with it. Transmitters connect to
receivers using the subscription matrix
3. To show the transmitters of a Dante device, click the + box
next to the desired device in the Dante Transmitters
panel, such as AXI22D-ConfRm1 (
– sign when the device expands.
4. To show the receivers of a Dante device, click the + box
next to the desired device in the Dante Receivers panel,
such as DMP128Plus-MainRack (
5. Click the intersection of the desired subscription between a
transmitter and a receiver (
input transmitter of the AXI22D-ConfRm1 and
AXI22D-ConfRm2 are routed to the EXP input receivers of
the DMP128Plus-MainRack.
A check mark at the intersection indicates the subscription
is made. A check mark also appears next to the receiver
channel.
NOTE: A receiver can connect to only one transmitter. A transmitter can connect to multiple receivers.

Disconnecting Inputs from Outputs

To undo routing, click the junction again to disconnect the receiver from the transmitter.
NOTE: After making changes to Dante network routing such as subscriptions, device names, or channel
labels, wait at least 5 seconds before disconnecting or powering down the devices. This ensures that
the new information is properly saved to those devices. Device level configuration such as sample rates,
latency, and clock settings are saved instantly.
). The + changes to a
1
).
2
). For example, the mic/line
3
Figure 36. Routing Tab of Network Screen
DMP 128 Plus • Dante Controller 27