Renaming A Receiver Or Transmitter - Extron electronics DMP 128 Plus User Manual

6. Click the Device Config tab (see figure 28,
Figure 28. Device Config Dialog Box
7. In the Rename Device panel, enter the new name of the device in the text field. No spaces are allowed in the
name. Names should be significant identifiers. For example, enter DMP128Plus-MainRack (
8. Click Apply (
3
9. Click Yes (see figure 29,
The new name is written to the Dante interface of the DMP 128 Plus AT. Repeat as necessary for all devices.
NOTE: The device name assigned in Dante Controller only applies to the Dante interface and does not
affect the device name recognized in DSP Configurator.
Figure 29. Rename Device Confirmation Diaglox Box

Renaming a Receiver or Transmitter

In addition to renaming devices, individual receiver and transmitter channels can be renamed in Dante Controller.
To better organize the various receivers and transmitters, it is recommended each receiver and each transmitter
be named using a description of the device they belong to, the location of the device, or the purpose of the
receiver or transmitter.
ATTENTION:
•
It is essential that a Dante device be named before audio subscriptions with other devices are
established. Existing subscriptions are removed when a device is renamed.
•
Il est essentiel qu'un appareil Dante soit nommé avant l'établissement des abonnements audio avec
d'autres appareils. Les abonnements existants sont supprimés lorsqu'un appareil est renommé.
To view the receiver or transmitter channels in Dante Controller, click the + sign next to the receiver or transmitter
device name to expand it. The + sign becomes a – sign when the device is expanded (see
page 23).
). A confirmation prompt opens.
) to confirm the new name, then close the Device Configuration dialog box.
1
) to open the Device Config page.
1
2
figure
DMP 128 Plus • Dante Controller
).
30, on
1
22