Extron electronics DMP 128 Plus User Manual page 84

Three drop-down lists are available (see
•
QoS Layer 2 — Select the PCP decimal value for layer 2 network frames. Default is 3 - Critical
Applications.
•
QoS Layer 3 (SIP) — Select the DSCP decimal value for layer 3 SIP network packets. Default is 24 - Call
Signaling.
•
QoS Layer 3 (RTP) — Select the DSCP decimal value for layer 3 RTP network packets. Default is
46 - Voice.
The LLDP-MED panel (
2
fields are greyed out. When enabled, the following fields are available:
• VLAN ID checkbox — Select to read the voice VLAN ID from the network and automatically configure the
DMP 128 Plus VLAN tag (VLAN must be selected as the interface for this feature to work)
• QoS PCP checkbox — Select to read PCP values from the network and automatically configure layer 2 QoS.
•
QoS DSCP checkbox — Select to read DSCP values from the network and automatically configure layer 3
QoS.
NOTE: VLAN ID, QoS PCP, and QoS DSCP values read from the network and applied to the DMP 128
Plus overwrite any manually specified values.
• Inventory checkbox — Select to send the DMP 128 Plus model number, part number, and firmware details
to the network switch.
•
Civic Location checkbox — Select to send the location details entered into the Civic Location panel.
This is useful when logging the physical location of the DMP 64 Plus for network management purposes.
Click Apply ( ) to save and apply all changes.
3
figure 58,
) allows user to Disable (default) or Enable the LLDP-MED. When disabled, all other
on page 76):
1
DMP 128 Plus • Internal Web Page 77