Extron electronics DMP 128 Plus User Manual page 25

3. When a connection with a device is established, the
Synchronize with Device dialog box opens (seefigure 23).
• Pull — Pulls the configuration file, presets, macros, and
ACP configurations from the device and displays it in the
DSP Configurator main workspace.
• Push — Pushes the configuration file, presets, and AT
Input Channel names open in DSP Configurator to the
connected device. This will overwrite any configuration
currently on the device.
NOTE: AT Input Channel names are only pushed
when the checkbox is selected.
Select the Selected radio button to open the DSP
Configurator dialog box with a list of the available presets
(see figure 24).
4. Once push or pull is completed, the current state of the
connected device is displayed in the DSP Configurator status
panel and the device is ready for further configuration.
Exit Live Mode and Enter Emulate Mode
1. Click the Emulate button in the DSP Configurator menu bar.
Alternatively, select Tools > Disconnect from Device or
press <F6> on the keyboard.
2. Click OK to confirm.
Emulate Mode
While in Emulate mode, DSP Configurator is functioning in an
"offline" state. Changes made to the configuration file are not
applied to a DMP 128 Plus.
In Emulate mode, the user can create and configure the software
as though a device was connected, except for any actions that
require direct connection to the device or information that is stored
only on the device. Once configuration is complete, the user can
switch to mode and apply the configuration to the device or
Live
save the configuration file to be loaded onto one or multiple devices
at a later time.
Creating configuration files in Emulate mode saves time by not requiring a device to be connected or present in
order for the bulk of DSP configuration to be completed.
NOTE: Not all menu options or actions are available in Emulate mode.
Figure 23. Synchronize with Device
Figure 24. Preset Selection
DMP 128 Plus • DSP Configurator Software 18