Extron electronics DMP 128 Plus User Manual page 30

Figure 30. Expanded Device View — Input and Output Names
TIP:
To simplify setup and operation of large matrix systems, rename the receiver and transmitter channels
to better indicate the source at the transmitters or receivers.
Renaming a Receiver or Transmitter
The default names shown in the Dante Receivers column are extracted from the Dante interface of the
connected device (see figure 30,
EXP_In-01 through EXP_In-48 because the DMP 128 Plus can receive signal at the 48 EXP inputs. Follow the
instructions on the next page to rename a receiver or transmitter.
To rename a DMP 128 Plus AT receiver or transmitter:
Figure 31. Device View Screen — Renaming a Receiver or Transmitter
1. Open the Device View dialog box of the DMP 128 Plus AT.
2. From the (Select a Dante Device..) drop-down list, select the name of the desired DMP 128 Plus (see
figure 31, ).
1
3. On the Device View screen, select the Receive tab or Transmit tab (
4. Click the name of the receiver or transmitter to be renamed. The name becomes a text box with a cursor (
and ). The DMP 128 Plus AT receivers are labelled
1 2
) as desired.
2
DMP 128 Plus • Dante Controller
).
3
23