Extron electronics DMP 128 Plus User Manual page 14

LAN ports (see figure 2
H
available for control network traffic (all models) and VolP network traffic (V models only) (see
Termination for Ethernet Communication
the DMP 128 Plus must be connected to the same network. The ports have two LEDs:
•
Link LED — Lights green steadily to indicate a LAN connection.
• Signal LED — Blinks amber to indicate LAN signal activity.
NOTE: Only the DMP 128 Plus V-models have two LAN/VoIP ports. Non-V-models only have one LAN
port.
LAN 1 defaults:
IP Address
192.168.254.254
LAN 2 (V models only) defaults:
IP Address
192.168.1.254
There are three ways the dual LAN ports can be configured on DMP 128 Plus V-models:
1. Control and VoIP traffic on one LAN port — Both control and VoIP traffic can be transported via a
single LAN port.
NOTE: By default, control and VoIP traffic are both transported on LAN 1.
2. Control and VoIP traffic on one LAN port using a VLAN — Both control and VoIP traffic can be
transported via a single physical LAN port while utilizing a VLAN for VoIP traffic.
3. Control and VoIP traffic on separate LAN ports — Control and VoIP traffic can be transported on
separate LAN ports with unique IP configurations.
The IP addresses can be configured via the internal web page (see
Toolbelt (see Software Installation
for device configuration).
AT ports (AT models only) — Four RJ-45 ports form a Gigabit switch that interfaces with the AT bus. The AT
I
expansion bus uses Dante
connect with other Dante-enabled devices to form a larger matrix (see
details on the software required to configure the AT extension bus).
The 4-port switch can be configured as two 2-port switches for redundant Dante configuration. In redundant
configuration, audio traffic is duplicated. Port 3 and 4 are primary switch (PRI), and Port 1 and 2 are the
secondary switch (SEC) (see
NOTE: Connecting an external power supply is not necessary when using PoE+ for power.
USB Audio port — Connect a Windows or Mac computer to this USB mini-B port to interface with the DMP
J
128 Plus as a USB audio device (see
details on configuring the USB audio). Audio sample rate is 48 kHz/16-bit.
Reset button and LED — Initiates three levels of resets. Use a pointed stylus, ballpoint pen, or small
K
screwdriver to access the recessed button (see
modes). When not displaying reset functions, the LED operates as a power indicator and matches the front
panel power LED.
on page 4) — One RJ-45 port (non-V models) or two RJ-45 ports (V models) are
on page 9 for wiring details). The host PC or control system and
Subnet Mask Gateway
255.255.255.0 0.0.0.0
Subnet Mask Gateway
255.255.255.0 0.0.0.0
on page 11 for details on downloading Toolbelt and the Toolbelt Help File
protocol for digital audio networking and allows DMP 128 Plus AT models to
®
Redundant Configuration
Configure USB Audio
Reset Modes
DHCP
OFF
DHCP
OFF
Communication Settings
Dante Controller
on page 25 for details on redundant mode).
on page 15 or the DSP Configurator Help File
on page 10 for details on the different reset
DMP 128 Plus • Installation
TP Cable
on page 71) or
on page 19 for
7