Extron electronics DMP 128 Plus User Manual page 17

Activation
Hold in the recessed rear
panel Reset button while
applying power to the unit.
NOTE: Do not operate with the default firmware loaded by this reset. Use it only to load the most current
firmware to the device.
Hold in the Reset button
until reset LEDs blink
twice (once at 3 seconds,
again at 6 seconds). Then,
release and press the
Reset button again within
1 second*.
Hold in the Reset button
until reset LEDs blink
three times (once at
3 seconds, again at
6 seconds, again at
9 seconds). Then, release
and press the Reset
button again within
1 second*.
NOTE: *For these modes, nothing happens for if the momentary press does not occur within 1 second.
Reset Modes
Result
The device reverts to the factory default firmware for a
single power cycle.
Sets the following back to factory default:
•
Digital I/O port mapping.
• IP address for LAN 1 (192.168.254.254).
•
IP address for LAN 2 (192.168.1.254)
• Subnet mask address for LAN 1 and LAN 2
(V-models only) = (255.255.255.0).
• Gateway IP address for LAN 1 and LAN 2
(V-models only) = (0.0.0.0).
Enable ARP capability.
Turns off DHCP for LAN 1 and LAN 2 (V-models only)
Performs a complete reset to factory defaults (except
the firmware).
•
Includes the factory defaults from the Reset All IP
Settings reset.
•
Mix-points are set to unity gain (0 dB) and the
following connections are made:
•
Input 1 is routed to output 1.
• Input 2 is routed to output 2.
•
Input 3 is routed to output 3.
•
Input 4 is routed to output 4.
•
Input 5 is routed to output 5.
•
Input 6 is routed to output 6.
•
Input 7 is routed to output 7.
•
Input 8 is routed to output 8.
•
All audio inputs are set to unity gain.
•
All outputs are unmuted and set to unity again.
• Any inserted or active DSP removed.
•
All preset and group master memory is cleared.
Purpose and Notes
Use this mode to revert to the
factory default firmware for a
single power cycle if
incompatibility issues arise
with user-loaded firmware. All
user files and settings are
maintained.
Use this mode to reset all IP
settings back to factory
defaults.
Use this mode to start over
with default configuration and
uploading, and also to
replace events.
DMP 128 Plus • Installation 10