Sending Sis Commands To Dante Audio Interface Devices Through The Dmp - Extron electronics DMP 128 Plus User Manual

Sending SIS Commands to Dante Audio Interface Devices through the DMP

The DMP 128 Plus can be set to pass through SIS commands to connected Dante-controlled Extron devices (see
Dante Control and Configuration
To send an SIS command to an AXI device connected to a DMP 128 Plus:
1. Connect the DMP and Dante-controlled devices to the same network via their AT ports (see
Network Setup
2. Connect to the DMP via the DataViewer or HyperTerminal utility (see
page 31).
3. Use the Set verbose mode command to set the DMP to Verbose mode 3 (see
page 42). Example:
Command
w3cv|
4. Use the Query available remote devices command (see
receive a list of Dante devices that are currently connected to the DMP. Example:
Command
waexpr|
NOTE: This list is similar to the list displayed within Dante Controller.
5. Use the Enable remote connection for listening command to display the remote Dante-controlled device
responses based on the list of devices provided in the response in step 4 (see
for listening
on page 50). Repeat if necessary for all desired devices. Example:
Command
wcAXI-XTP-RoomA*1expr|
NOTE: AXI devices can be set up for listening even if not currently connected to the DMP unit.
6. To verify that the DMP is listening to the correct remote devices, use the Query remote devices being listened
to command to display a list of all remote devices enabled with the command in step 5 (see
devices being listened to
Command
wlexpr|
7. Send the desired command to the AXI and confirm the correct response is received.
• When entering a command, use the "w" character in place of the <Esc> key and the "pipe" character ( | )
in place of a carriage-return. Failing to do so may cause the command to fail.
•
The closing bracket ( } ) is necessary to successfully end a command before attempting to send a new
command. Example:
Command
{dante@AXI-XTP-
RoomA:wg40000*-10AU|}
NOTE: The DMP provides the tag showing the Dante-controlled remote device name while the remote
device provides the response for the SIS command.
on page 50 for SIS commands).
on page 24).
Response
]
Vrb3
Response
ExprA•AXI-XTP-RoomA
AXI-XTP-RoomB
Response
ExprCAXI-XTP-RoomA*1
on page 50). Example:
Response
ExprL•AXI-XTP-RoomA
Response
{dante@AXI-XTP-RoomA}DsG40000*-10
}
SIS Configuration and Control
Query available remote devices
]
]]
]
]
DMP 128 Plus • Dante Controller
Physical Dante
Set verbose mode on
on page 50) to
Enable remote connection
Query remote
]
on
28