Extron electronics DMP 128 Plus User Manual page 87

Advanced
The Advanced tab allows the user to make changes to line re-registration, RTP port range, and outgoing calls
(see figure 61).
Figure 61. VoIP Network Advanced Tab
Registration — Click the Automatic Line Re-registration checkbox to enable or disable automatic line
1
re-registration. If enabled, use Retry Count and Retry Delay drop-down lists to set the necessary values.
Click Apply to save changes.
RTP Port Range — Use the Start Port and End Port drop-down lists to set the necessary values. The
2
valid port range is 1024-65534.
NOTES:
•
Changes to the RTP Port Range settings will take effect immediately whether using direct input or
the stepper buttons.
•
The Start Port value must be lower than the End Port value.
• The Set Defaults button sets the Start Port to 50000 and the End Port to 50999.
Outgoing Calls — Disabled by default. If required, click the checkbox to enable codec compatibility mode.
3
DMP 128 Plus • Internal Web Page 80