Renaming The Dmp 128 Plus At In Dante Controller - Extron electronics DMP 128 Plus User Manual

Renaming the DMP 128 Plus AT in Dante Controller

NOTE: Dante device naming can also be done via DSP Configurator (see the DSP Configuration Help File)
for more details.
1. Ensure that the control computer and a single DMP 128 Plus are connected to the same network.
2. From the control computer Start menu select:
All Programs > Audinate > Dante Controller > Dante Controller
3. The Dante Controller - Network View screen opens. All Dante
devices on the network are discovered and listed.
4. From the Device menu, select Device View or press <Ctrl+D> on
the keyboard (see figure 25).
5. The Dante Controller - Device View dialog opens. Select the
device being configured from the (Select a Dante Device...)
drop-down list (see figure 26,
Figure 26. Dante View and Select a Dante Device Drop-Down
NOTES:
•
If there are multiple DMP 128 Plus AT devices connected to the network that have not been
renamed, obtain the Dante interface media access code (MAC) address of the desired device from
the white label on the rear panel of the device in order to identify it in Dante Controller.
•
There are multiple MAC addresses listed on the rear panel of a DMP 128 Plus AT, one for the LAN
port and one for the Dante interface. The Dante interface MAC address is listed beneath the LAN
port MAC address.
The Device View dialog populates with the selected DMP 128 Plus AT information (see figure 27).
Figure 27. Populated Device View Dialog Box
)
1
Figure 25. Device View
DMP 128 Plus • Dante Controller 21