Steering Wheel; Tilt/Telescoping Steering Column - Jeep GLADIATOR 2022 Owner's Manual

3. Place the base of the exterior mirror into the hole on
the door, and support it while attaching the three
mirror bolts through the inside of the door using a
#T40 Torx head driver.
Attach Exterior Mirror
1 — Support Mirror From Outside
2 — Attach Three Mirror Bolts From Inside
NOTE:
Recommended torque for the mirror bolts is 5.9 ft· lb
/ 8.0 N·m.
4. Repeat steps 1-3 on the opposite side front door.
Half-Door Removal
To remove the half-doors, repeat the installation steps
in reverse order.
NOTE:
When removing the upper half-doors, push upward
firmly on the middle of the upper half-door until the
posts detach from the lower half.
Push Upward To Remove Upper Half-Door
1 — Fully Seated Upper Half-Door
2 — Push Upward On Middle Of Upper Half-Door

STEERING WHEEL

TILT/TELESCOPING STEERING
COLUMN
This feature allows you to tilt the steering column
upward or downward. It also allows you to lengthen or
shorten the steering column. The tilt/telescoping con-
trol is located below the steering wheel at the end of
the steering column.
GETTING TO KNOW YOUR VEHICLE
Tilt/Telescoping Steering Column Control
To unlock the steering column, push the control down-
ward (toward the floor). To tilt the steering column,
move the steering wheel upward or downward as
desired. To lengthen or shorten the steering column,
pull the steering wheel outward or push it inward as
desired. To lock the steering column in position, push
the control upward until fully engaged.
WARNING!
Do not adjust the steering column while driving.
Adjusting the steering column while driving or driving
with the steering column unlocked, could cause the
driver to lose control of the vehicle. Failure to follow
this warning may result in serious injury or death.
37
2