To Start The Engine While In Autostop Mode; To Manually Turn Off The Stop/Start System - Jeep Wrangler Owner's Manual

108 STARTING AND OPERATING
 Battery temperature is too warm or cold.
 Battery charge is low.
 The vehicle is on a steep grade.
 Cabin heating or cooling is in process and an accept-
able cabin temperature has not been achieved.
 HVAC is set to full defrost mode at a high blower speed.
 HVAC is set to MAX A/C.
 Engine has not reached normal operating temperature.
 Engine temperature is too high.
 The transmission is not in a forward gear.
 Hood is open.
 Transfer case is in 4L or N (Neutral).
 Brake pedal is not pressed with sufficient pressure.
 Accelerator pedal input.
 Vehicle speed threshold is not achieved from previous
Autostop.
 Steering angle is beyond threshold.
 ACC is on and speed is set.
 Vehicle is at high altitude.
 System fault is present.
 Stop/Start OFF switch is pushed.
It may be possible for the vehicle to be driven several
times without the Stop/Start system going into a STOP/
START READY state under more extreme conditions of the
previously listed items.
T S T E W
O TART HE NGINE HILE
A M
UTOSTOP ODE
While in a forward gear, the engine will start when the
brake pedal is released or the accelerator pedal is
pressed. The transmission will automatically re-engage
upon engine restart.
Conditions That Will Cause The Engine To Start
Automatically While In Autostop Mode:
 The transmission selector is moved out of DRIVE.
 To maintain cabin temperature comfort.
 Actual cabin temperature is significantly different than
temperature set on Auto HVAC.
 HVAC is set to full defrost mode.
 HVAC system temperature or fan speed is manually
adjusted.
 Battery voltage drops too low.
 Low brake vacuum (e.g. after several brake pedal appli-
cations).
 Stop/Start OFF switch is pushed.
 A Stop/Start system error occurs.
 Stop/Start Autostop Active time exceeds five minutes.
 Four-wheel drive system is put into 4L or N (Neutral).
 Steering wheel is turned beyond threshold.
I
N
T M
O ANUALLY
S S
TART YSTEM
Stop/Start OFF Switch
Push the Stop/Start OFF switch (located on the switch
bank). The light on the switch will illuminate. The "STOP/
START OFF" message will appear in instrument cluster
display within the Stop/Start section
T O T S /
URN FF HE TOP
page 72.
Ú