Driver Memory Settings - If Equipped; Programming The Memory Feature; Linking And Unlinking The Remote Keyless Entry Key Fob To Memory - Jeep Compass 2023 Owner's Manual

WARNING!
 Do not place anything on the steering wheel that
insulates against heat, such as a blanket or steering
wheel covers of any type and material. This may
cause the steering wheel heater to overheat.
DRIVER MEMORY SETTINGS — IF EQUIPPED
This feature allows the driver to save up to two different
memory profiles for easy recall through a memory switch.
Each memory profile saves desired position settings for
the following features:
 Driver seat position
 Easy Entry/Exit seat (if equipped)
 A set of desired radio station presets
NOTE:
Your vehicle is equipped with two key fobs, each can be
linked to either memory position 1 or 2.
The memory setting switch is located on the driver's door
trim panel. The switch consists of three buttons:
 The set (S) button, which is used to activate the
memory save function.
 The (1) and (2) buttons which are used to recall either
of two saved memory profiles.
Memory Switches
P T M
ROGRAMMING HE EMORY
To create a new memory profile, perform the following:
NOTE:
Saving a new memory profile will erase an existing profile
from memory.
1. Place the vehicle's ignition in the ON position.
2. Adjust all memory profile settings to desired
preferences (i.e., seat and radio station presets).
3. Push the set (S) button on the memory switch, and
then push the desired memory button (1 or 2) within
five seconds. The instrument cluster display will
display which memory position is being set.
NOTE:
Memory profiles can be set without the vehicle in PARK,
but the vehicle must be in PARK to recall a memory profile.
GETTING TO KNOW YOUR VEHICLE
L A U
INKING ND
K E
EYLESS NTRY
Your remote keyless entry key fob can be programmed to
recall one of two saved memory profiles.
NOTE:
Before programming your key fob you must select the
"Memory Linked To FOB" feature through the Uconnect
Settings page 145.
Ú
To program your key fob, perform the following:
1. Place the vehicle's ignition in the OFF position.
F
2. Select the desired memory profile (1) or (2).
EATURE
3. Push and release the set (S) button on the
memory switch, then within five seconds push and
release the button labeled (1) or (2) accordingly.
"Memory Profile Set" (1 or 2) will display in the
instrument cluster display.
4. Push and release the lock button on the key fob
within 10 seconds.
NOTE:
Your key fob can be unlinked from your memory settings
by pushing the set (S) button, followed by pushing the
unlock button on the key fob within 10 seconds.
25
T R
NLINKING HE EMOTE
K F T M
EY OB O EMORY
2