Logging In To The Web Interface - Lenovo Flex System x440 Compute Node Installation And Service Manual

The rear of the network access tag lists the IPv6 link local address (LLA), as shown in the following
illustration.
The MAC address is also available through the Setup utility, the CMM cinstatus command, and the CMM
web interface.
• For more information about the Setup utility, see
• For more information about the CMM cinstatus command, see the
Module: Command-Line Interface Reference Guide" at http://pic.dhe.ibm.com/infocenter/flexsys/information/
topic/com.lenovo.acc.cmm.doc/cli_command_ cinstatus.html
• From the CMM web interface, select Compute Nodes from the Chassis Management menu. For more
information, see the
the "Flex System Chassis Management Module: User's Guide" at http://pic.dhe.ibm.com/
infocenter/flexsys/information/topic/com.lenovo.acc.cmm.doc/ cmm_user_ guide.html
are described in the CMM web interface online help.
Note: If the network access tag is missing from the front of the compute node, you can also locate the MAC
address on a label located on the bottom of the compute node.

Logging in to the web interface

Use these instruction to log in to the IMM2 web interface.
Notes:
• If you are logging on to the IMM2 for the first time after installation, the IMM2 defaults to Dynamic Host
Configuration Protocol (DHCP). If a DHCP host is not available, the IMM2 assigns a static IP address
between 192.168.70.101 and 192.168.70.114, depending on the bay in which the compute node is
installed.
• You can also assign IP addresses through the CMM ifconfig command. For more information about the
CMM ifconfig command, see the
Reference Guide" at http://pic.dhe.ibm.com/infocenter/flexsys/information/topic/com.lenovo.acc.cmm.doc/cli_
command_ ifconfig.html
• To assign IP addresses from the CMM web interface, click Mgt Module Management ➙ Network ➙
Ethernet.
Lenovo Flex System x440 Compute NodeInstallation and Service Guide
46
"Flex System Chassis Management Module: Command-Line Interface
.
"Using the Setup utility" on page
"Flex System Chassis Management
.
28.
. All fields and options