Lenovo Flex System x440 Compute Node Installation And Service Manual page 62

Step 5. When you are prompted Can Windows connect to Windows Update to search for software?, select No,
not this time. Click Next to continue.
Step 6. When you are prompted What do you want the wizard to do?, select Install from a list or specific
location (Advanced). Click Next to continue.
Step 7. When you are prompted Please choose your search and installation options, select Don't search. I
will choose the driver to install. Click Next to continue.
Step 8. When you are prompted Select a hardware type, and then click Next, select Network adapters.
Click Next to continue.
Step 9. When you are prompted with the statement Completing the Found New Hardware Wizard, click Finish.
A new local area connection appears. If the message This connection has limited or no
connectivity is displayed, ignore this message.
Step 10. Return to the Device Manager. IBM USB Remote NDIS Network Device or Lenovo USB Remote
NDIS Network Device appears under Network Adapters.
Step 11. Use the Setup utility to view or set the IP address. See
50 for information about the IP addresses.
a. Connect a keyboard, monitor, and mouse to the console breakout cable and connect the
console breakout cable to the compute node.
b. Turn on the compute node (see
c. When the prompt Press <F1> Setup is displayed, press F1. If you have set an administrator
password, you must type the administrator password to access the full Setup utility menu. If
you do not type the administrator password, a limited Setup utility menu is available.
Select System Settings → Integrated Management Module → Network Configuration.
d.
e. Locate the IP address.
f. Exit from the Setup utility.
Installing the LAN over USB Linux device driver
Versions of Linux since RHEL5 Update 3 and SLES10 Service Pack 2 support the LAN over USB interface by
default. This interface is detected and displayed during the installation of these operating systems.
See Table 3 "LAN over USB addresses" on page 50
Note: Older Linux distributions might not detect the LAN over USB interface and might require manual
configuration. For information about configuring LAN over USB on specific Linux distributions, see
www.ibm.com/support/entry/
The IMM2 LAN over USB interface requires that the usbnet and cdc_ether device drivers be loaded. If the
drivers have not been installed, use modprobe to install them. When these drivers are installed, the IMM2
USB network interface is shown as a network device in the operating system. To discover the name that the
operating system has assigned to the IMM2 USB network interface, type
dmesg | grep -i cdc ether
Lenovo Flex System x440 Compute NodeInstallation and Service Guide
52
"Turning on the compute node" on page
for information about the IP addresses.
portal/docdisplay?lndocid=MIGR-5083207.
Table 3 "LAN over USB addresses" on page
16).
http://