Lenovo Flex System x440 Compute Node Installation And Service Manual page 190

Complete the following steps:
1. Check component firmware level and upgrade if necessary. The installed firmware level can be
found in the DSA Diagnostic Event Log within the Firmware/VPD section for this component.
2. Rerun the test.
3. If failure remains, refer to "Troubleshooting by symptom" in the system "Installation and Service
Guide" for the next corrective action.
Related links
–
Lenovo Support website
–
Latest level of DSA
• 405-907-000 : BRCM:TestLEDs Test Failed
A failure was detected while verifying operation of the status LEDs.
Recoverable
No
Severity
Error
Serviceable
Yes
Automatically notify support
No
User Response
Complete the following steps:
1. Check component firmware level and upgrade if necessary. The installed firmware level can be
found in the DSA Diagnostic Event Log within the Firmware/VPD section for this component.
2. Rerun the test.
3. If failure remains, refer to "Troubleshooting by symptom" in the system "Installation and Service
Guide" for the next corrective action.
Related links
–
Lenovo Support website
–
Latest level of DSA
DSA Brocade test results
The following messages can result when you run the Brocade test.
Test results for the DSA Brocade test
The following messages can result when you run the DSA Brocade test.
• 218-000-000 : Brocade:MemoryTest Passed
The test passed.
Recoverable
No
Severity
Event
Serviceable
No
Automatically notify support
Lenovo Flex System x440 Compute NodeInstallation and Service Guide
180