Lenovo Flex System x440 Compute Node Installation And Service Manual page 337

1. Remove the I/O expansion adapter in I/O expansion connector 3.
2. Try to power on the chassis.
– If the chassis successfully powers on, complete the following steps:
a. Check the
compatible with the chassis.
b. Inspect the previously installed components for physical damage.
– If the chassis does not successfully power on or if this is not the first occurrence of this
problem, replace the I/O expansion adapter.
• 80070617-2c04ffff : Sensor Mezz Exp 4 Fault has transitioned to non-recoverable.
A problem was detected in the I/O expansion adapter in I/O expansion connector 4. The adapter is unable
to initialize.
May also be shown as 800706172c04ffff or 0x800706172c04ffff
Severity
Error
Serviceable
Yes
Automatically notify support
No
Alert Category
Critical - Other
SNMP Trap ID
50
CIM Information
Prefix: PLAT ID: 0530
User Response
Complete the following steps:
1. Remove the I/O expansion adapter in I/O expansion connector 4.
2. Try to power on the chassis.
– If the chassis successfully powers on, complete the following steps:
a. Check the
compatible with the chassis.
b. Inspect the previously installed components for physical damage.
– If the chassis does not successfully power on or if this is not the first occurrence of this
problem, replace the I/O expansion adapter.
• 8008001b-1f07ffff : Device Periscope 1 has been removed from unit
[PhysicalPackageElementName].
The fabric connector for LAN On Motherboard (LOM) in location 1 is not present.
May also be shown as 8008001b1f07ffff or 0x8008001b1f07ffff
Severity
Info
Serviceable
No
ServerProven website to make sure that recently installed components are
ServerProven website to make sure that recently installed components are
.
Chapter 6 Troubleshooting
327