Lenovo Flex System x440 Compute Node Installation And Service Manual page 362

The temperature of the specified microprocessor has risen above its specified threshold.
May also be shown as 806f01072584ffff or 0x806f01072584ffff
Severity
Error
Serviceable
Yes
Automatically notify support
No
Alert Category
Critical - Temperature
SNMP Trap ID
0
CIM Information
Prefix: PLAT ID: 0036
User Response
Complete the following steps until the problem is solved:
1. Check the Chassis Management Module or Flex System Manager event log for any fan- or
cooling-related issues.
2. Make sure that the airflow at the front and rear of the chassis is not obstructed and that fillers are
in place and correctly installed.
3. Make sure that the room temperature is within operating specifications.
4. Make sure that the heat sink for the specified microprocessor is securely installed.
5. Make sure that the heat sink for the specified microprocessor is installed correctly and the
thermal material is correctly applied.
6. Replace the specified microprocessor.
• 806f0109-0701ffff : system board 1 has been Power Cycled.
The compute node has been powered off and powered on.
May also be shown as 806f01090701ffff or 0x806f01090701ffff
Severity
Info
Serviceable
No
Automatically notify support
No
Alert Category
System - Other
SNMP Trap ID
CIM Information
Prefix: PLAT ID: 0108
User Response
Information only; no action is required.
Lenovo Flex System x440 Compute NodeInstallation and Service Guide
352