Lenovo Flex System x440 Compute Node Installation And Service Manual page 851

1. Check the IBM support site for an applicable service bulletin or firmware update that applies to this
error.
2. Update the UEFI image.
3. Replace the system board.
• S.3050007: [S.3050007] A firmware fault has been detected in the UEFI image.
[S.3050007] A firmware fault has been detected in the UEFI image.
Severity: Error
User Response:
Complete the following steps:
1. Check the IBM support site for an applicable service bulletin or firmware update that applies to this
error.
2. Update the UEFI image.
3. Replace the system board.
• S.3058004: [S.3058004] A Three Strike boot failure has occurred. The system has booted with
default UEFI settings.
[S.3058004] A Three Strike boot failure has occurred. The system has booted with default UEFI settings.
Severity: Error
User Response:
Complete the following steps:
1. This event resets UEFI to the default settings for the next boot. If successful, the Setup Utility is
displayed. The original UEFI settings are still present.
2. If you did not intentionally trigger the reboots, check logs for probable cause.
3. Undo recent system changes (settings or devices added). If there were no recent system changes,
remove all options, and then remove the CMOS battery for 30 seconds to clear CMOS contents.
Verify that the system boots. Then, re-install the options one at a time to locate the problem.
4. Check the IBM support site for an applicable service bulletin or firmware update that applies to this
error.
5. Update the UEFI firmware.
6. Remove and re-install CMOS battery for 30 seconds to clear CMOS contents
7. Replace the system board.
• S.3060007: [S.3060007] A firmware fault has been detected in the UEFI image.
[S.3060007] A firmware fault has been detected in the UEFI image.
Severity: Error
User Response:
Complete the following steps:
1. Check the IBM support site for an applicable service bulletin or firmware update that applies to this
error.
2. Update the UEFI image.
3. Replace the system board.
• S.3070007: [S.3070007] A firmware fault has been detected in the UEFI image.
[S.3070007] A firmware fault has been detected in the UEFI image.
.
Chapter 6 Troubleshooting
841