Lenovo Flex System x440 Compute Node Installation And Service Manual page 849

[I.580A6] Memory spare copy has completed successfully.
Severity: Info
User Response:
Complete the following steps:
Check system log for related DIMM failures and replace those DIMMs.
• S.1100C: [S.1100C] An uncorrectable error has been detected on processor %.
[S.1100C] An uncorrectable error has been detected on processor %.
Severity: Error
User Response:
Complete the following steps:
1. Check the IBM support site for an applicable service bulletin or firmware update that applies to this
error.
2. Reboot the system. If problem persists, contact Support.
• S.2011001: [S.2011001] An Uncorrected PCIe Error has Occurred at Bus % Device % Function %.
The Vendor ID for the device is % and the Device ID is %.
[S.2011001] An Uncorrected PCIe Error has Occurred at Bus % Device % Function %. The Vendor ID for
the device is % and the Device ID is %.
Severity: Error
User Response:
Complete the following steps:
1. If this compute node and/or any attached cables were recently installed, moved, serviced or
upgraded,
a. Reseat the adapter and any attached cables.
b. Reload the device driver.
c. If device is not recognized, reconfiguring slot to Gen1 or Gen2 may be required. Gen1/Gen2
settings can be configured via F1 Setup -> System Settings -> Devices and I/O Ports -> PCIe
Gen1/Gen2/Gen3 Speed Selection, or the ASU Utility.
2. Check the IBM support site for an applicable device driver, firmware update, or other information that
applies to this error. Load the new device driver and install any required firmware updates.
3. If the problem persists, remove the adapter. If system reboots successfully without the adapter,
replace that adapter.
4. Replace the processor.
• S.2018001: [S.2018001] An Uncorrected PCIe Error has Occurred at Bus % Device % Function %.
The Vendor ID for the device is % and the Device ID is %.
[S.2018001] An Uncorrected PCIe Error has Occurred at Bus % Device % Function %. The Vendor ID for
the device is % and the Device ID is %.
Severity: Error
User Response:
Complete the following steps:
1. If this compute node and/or any attached cables were recently installed, moved, serviced or
upgraded:
a. Reseat the adapter and any attached cables.
.
Chapter 6 Troubleshooting
839