Lenovo Flex System x440 Compute Node Installation And Service Manual page 932

chassis" on page
on the new base assembly because the old bezel was damaged and did not transfer the Tag from
the old bezel to the new bezel, install Tag 3 on the lower right corner of the new bezel. If you
installed the old bezel on the new base assembly or transferred the Tag from the old bezel to the
new bezel, discard Tag 3.
After you transfer components to the replacement base assembly, complete the following steps:
1. Install the compute node in the chassis (see
instructions).
2. Use the CMM Web Interface to restore the IP address of the compute node IMM. See
interface in the "Flex System Chassis Management Module: User's Guide" at http://pic.dhe.ibm.com/
infocenter/flexsys/information/topic/com.lenovo.acc.cmm.doc/cmm_ug_ startwebinterface.html
information.
Note: If you configured static IP addresses, you will not be able to access the node remotely or from a
management device until the IP address of the IMM is restored.
3. Reactivate any Features on Demand features. Instructions for automating the activation of features and
installing activation keys is in the Lenovo Features on Demand Users Guide. To download the document,
go to
https://fod.lenovo.com/lkms
4. Update the Universally Unique Identifier (UUID) and DMI/SMBIOS data with new vital product data
(VPD). Use the Advanced Settings Utility to update the UUID and DMI/SMBIOS data (see
Universally Unique Identifier and DMI/SMBIOS data" on page
5. Update the compute node with the latest firmware or restore the preexisting firmware (see
firmware and device drivers" on page 25
Lenovo Flex System x440 Compute NodeInstallation and Service Guide
922
881) and Tag 2 on the bottom of the compute node. If you installed the new bezel
"Installing a compute node in a chassis" on page 881
, log in, and click Help.
for more information).
35).
for
Starting the web
for more
"Updating the
"Updating