Lenovo Flex System x440 Compute Node Installation And Service Manual page 846

Complete the following steps:
1. Verify that matching processors are installed in the correct processor sockets.
2. Check the IBM support site for an applicable service bulletin or firmware update that applies to this
processor error.
3. Replace the system board.
• I.18010: [I.18010] A processor stepping mismatch has been detected for one or more processor
packages.
[I.18010] A processor stepping mismatch has been detected for one or more processor packages.
Severity: Info
User Response:
Complete the following steps:
1. Verify that matching processors are installed in the correct processor sockets.
2. Check the IBM support site for an applicable service bulletin or firmware update that applies to this
processor error.
3. Replace the system board.
• I.2018002: [I.2018002] The device found at Bus % Device % Function % could not be configured
due to resource constraints. The Vendor ID for the device is % and the Device ID is %.
[I.2018002] The device found at Bus % Device % Function % could not be configured due to resource
constraints. The Vendor ID for the device is % and the Device ID is %.
Severity: Info
User Response:
Complete the following steps:
1. If this PCIe device and/or any attached cables were recently installed, moved, serviced or upgraded,
reseat the adapter and any attached cables.
2. Check the IBM support site for any applicable service bulletin or UEFI or adapter firmware update
that applies to this error. NOTE: It may be necessary to disable unused option ROMs from UEFI F1
setup or ASU or using adapter manufacturer utilities so that adapter firmware can be updated.
3. Move the adapter to a different slot. If a slot is not available or error recurs, replace the adapter.
4. If the adapter was moved to a different slot and the error did not recur, verify that this is not a system
limitation. Then replace the system board. Also, if this is not the initial installation and the error
persists after adapter replacement, replace the system board.
• I.2018003: [I.2018003] A bad option ROM checksum was detected for the device found at Bus %
Device % Function %. The Vendor ID for the device is % and the Device ID is %.
[I.2018003] A bad option ROM checksum was detected for the device found at Bus % Device % Function
%. The Vendor ID for the device is % and the Device ID is %.
Severity: Info
User Response:
Complete the following steps:
1. If this PCIe device and/or any attached cables were recently installed, moved, serviced or upgraded,
reseat the adapter and any attached cables.
2. Move the adapter to a different system slot, if available.
3. Check the IBM support site for any applicable service bulletin or UEFI or adapter firmware update
that applies to this error. NOTE: It may be necessary to configure slot to Gen1 or to use special utility
Lenovo Flex System x440 Compute NodeInstallation and Service Guide
836