Lenovo Flex System x440 Compute Node Installation And Service Manual page 158

Serviceable
Yes
Automatically notify support
No
User Response
Complete the following steps:
1. Clean the tape drive using the appropriate cleaning media and install new media.
2. Run the test again.
3. Make sure that the drive firmware is at the latest level.
4. Rerun the test after upgrading to the latest firmware level.
5. Make sure that the DSA Diagnostic code is at the latest level.
6. Run the test again.
7. Check the system firmware level and upgrade if necessary.
8. Run the test again.
9. If the failure remains, refer to "Troubleshooting by symptom" in the system "Installation and
Service Guide" for the next corrective action.
Related links
–
Lenovo Support website
– Latest level of DSA
• 264-907-000 : Tape Test Failed
An error was found in the block address somewhere.
Recoverable
No
Severity
Error
Serviceable
Yes
Automatically notify support
No
User Response
Complete the following steps:
1. Clean the tape drive using the appropriate cleaning media and install new media.
Related links
– Lenovo Support website
–
Latest level of DSA
• 264-908-000 : Tape Test Failed
An error was found in getting tape capacity.
Recoverable
No
Severity
Error
Serviceable
Yes
Lenovo Flex System x440 Compute NodeInstallation and Service Guide
148