Removing A Dimm - Lenovo Flex System x440 Compute Node Installation And Service Manual

After you install the compute node cover, install the compute node into the chassis (see
node in a chassis" on page 881

Removing a DIMM

Use this information to remove a dual inline memory module (DIMM).
Before you remove a DIMM, complete the following steps:
1. Read "Safety" on page iii
2. If the compute node is installed in a Flex System chassis, remove it (see
from a chassis" on page 880
3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with the
bezel pointing toward you.
After you install or remove a DIMM, you must change and save the new configuration information by using
the Setup utility. When you turn on the compute node, a message indicates that the memory configuration
has changed. Start the Setup utility and select Save Settings (see
more information) to save changes.
To remove a DIMM, complete the following steps.
Step 1. Remove the cover (see
Step 2. Remove the air baffle that is installed over the DIMM connector.
for instructions).
and "Installation guidelines" on page
for instructions).
"Removing the compute node cover" on page
.
Chapter 7 Installing, removing, and replacing compute node components
"Installing a compute
879.
"Removing a compute node
"Using the Setup utility" on page 28
888).
for
891