Lenovo Flex System x440 Compute Node Installation And Service Manual page 47

where zzzzzzz is the 7-character serial number of the compute node.
Step 3. Enter the following command:
asu set SYSTEM_PROD_DATA.SysEncloseAssetTag aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa [--host ipaddress]
where aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa is the 33-character asset tag number of the compute
node.
Step 4. Restart the IMM.
Step 5. Restart the server.
Remotely over a LAN
If you omit any optional parameter, the default value is used.
To update the UUID, in the ASU command-line interface, enter the following command:
asu set SYSTEM_PROD_DATA.SysInfoUUID uuid --host ipaddress
where:
uuid
is the user-assigned hexadecimal value, up to 16 bytes, that identifies the compute node.
ipaddress
is the external LAN IP address of the IMM2.
userid
is the IMM2 account name (1 of 12 accounts). The default is USERID.
password
is the IMM2 account password (1 of 12 accounts). The default is PASSW0RD (with a zero, not the letter
O).
To update the DMI/SMBIOS data, complete the following steps:
Step 1. In the ASU command-line interface, enter the following command:
asu set SYSTEM_PROD_DATA.SysInfoProdName xxxxyyy --host ipaddress
where:
xxxx
is the 4-digit machine type of the compute node.
yyy
is the 3-digit model number of the compute node.
ipaddress
is the external LAN IP address of the IMM2.
userid
is the IMM2 account name (1 of 12 accounts). The default is USERID.
password
is the IMM2 account password (1 or 12 accounts). The default is PASSW0RD (with a zero, not
the letter O).
Step 2. Enter the following command:
asu set SYSTEM_PROD_DATA.SysInfoSerialNum zzzzzzz --host ipaddress
[--user userid][--password password]
[--user userid][--password password]
[--user userid][--password password]
Chapter 2
.
Configuring
37
[--