Modify Wallstation Actions - Cooper WaveLinx Lite User And Programming Manual

Table of Contents

Modify Wallstation Actions

Wallstations will operate according to their default behavior described in the "WaveLinx Lite Device Reference Sheets" starting on page 9. Each

wallstation button's default response can be modified to respond in a different manner. Internet connection is not needed to modify

wallstations but connection to the WaveLinx Lite device/network is required.

WaveLinx Lite 4.0 wallstations support the following actions (commands).

• No action: The button will not perform any command if pressed.

• Select scene: The button will issue the selected scene to the designated area with a 1.5 second fade rate.

• Zone level: The button will operate the selected zone(s) in the selected area to the defined level with a 1.5 second fade rate. Select to

control a single zone or all zones in the area. Non dimmable and receptacle zones will turn ON if commanded to a level from 1% to 100%

and will turn OFF with a level of 0%.

• Raise level: The button will gradually raise the light level for the selected dimmable zone in the selected area. Select to control a single

zone or all zones in the area. A press and release of the button will increase the light level 1% per press. A hold of the button will increase

the light level 15% per second. If non dimmable or receptacle zones are included in this command, devices will remain ON as long as levels

are within 1% to 100% and will turn OFF when the level reaches 0%.

• Lower level: The button will gradually lower the light level for the selected dimmable zone in the selected area. Select to control a single

zone or all zones in the area. A press and release of the button will decrease the light level 1% per press. A hold of the button will decrease

the light level 15% per second. If non dimmable or receptacle zones are included in this command, devices will remain ON as long as levels

are within 1% to 100% and will turn OFF when the level reaches 0%.

To modify a wallstation:

1: Bring the mobile device within range (within 60 feet) of any line voltage powered provisioned WaveLinx Lite device in the desired area.

2: Ensure that the mobile device Bluetooth is turned on, and then open the WaveLinx Lite Mobile Application.

3: In the site list, select a site.

4: In the area list, select the desired area. After a short delay, verify that the area shows that the mobile application is connected to the network.

Tap on the

icon if it is necessary to refresh the connection.

5: In the 'Devices in Area' list, locate the wallstation. Tap on the wallstation to open it for configuration. The mobile application will display the

wallstation's configuration on the screen.

• Line voltage wallstations only: If needed, use the identify icon '

• Battery powered wallstations only: After selecting the wallstation, when prompted to wake the station, go to the physical wallstation and

press any button. On the app screen, tap 'Confirm'.

6: Tap the button on the screen display to edit the assigned button action.

Select the area

Note: Each wallstation model will be shown with buttons that correspond to that model's button configuration.

To make a change to a battery powered wallstation, there must be a Bluetooth communication connection through a line voltage powered WaveLinx Lite device.

www.cooperlighting.com

Select the site

If needed, use 'identify' to

locate the correct device (line

voltage wallstations only)

' to flash the wallstation LED until the correct one is identified.

Not connected

Connected

Verify network

connection

Select a wallstation

Battery wallstations