Table of Contents
Advertisement
User Manual: WaveLinx Lite (4.0)
Modify Devices in Standalone Areas
After devices are provisioned, it is possible to change the device name. Devices may also be deleted, returning them to an unprovisioned state.
Internet connection is not needed to modify a device but connection to the WaveLinx Lite device is required. The mobile device will need to be
in range and as close as possible (within 60 feet) to the device being modified.
Rename a Device
A device can be renamed in the standalone area. This process requires a Bluetooth connection to the device.
To rename a device:
1: Bring the mobile device within range (within 60 feet) of the desired device.
2: Ensure that the mobile device Bluetooth is turned on, and then open the WaveLinx Lite Mobile Application.
3: In the site list, select a site.
4: In the area list, select the desired area.
5: Select the device from the list of 'Devices in this Area'.
6: In the 'Dimmable' tab, tap the identify icon '
7: Tap the pencil icon '
'.
8: Change the device name, and then tap 'Save'.
Select the site
Select the area
Add/Provision a New Device
To add an additional new device to an existing area, see "Step 5: Provision Area Devices" on page 63.
' to flash the load, verifying that the correct load is selected.
Tap the identify icon
to verify it is the
correct device
Locate and tap to
open the device
Tap the pencil icon
Edit the name
Tap 'Save'
www.cooperlighting.com
121
Advertisement
Table of Contents
