Table of Contents
Advertisement
User Manual: WaveLinx Lite (4.0)
Adjust Occupancy Sensor Command Settings in a Standalone Area
To change the hold time, occupied level, unoccupied level, and/or energy saver settings for a sensor in a standalone area:
1: Ensure that the mobile device Bluetooth is turned on, and then open the WaveLinx Lite Mobile Application.
2: In the site list, select a site and then in the area list, select the standalone area.
3: Bring the mobile device within range (within 60 feet) of the desired device and then select the device from the 'Devices in this Area' section.
4: Once the device connects and opens, tap the 'Occupancy...' tab, and then tap the identify icon '
verify that it is the expected device. The device should respond with the identification behavior described in the device reference sheet
section beginning on page 9.
After 15 seconds the device will disconnect and return to normal operation or tap the identify icon '
the command and disconnect manually. If an unintended device responds, try the next device and continue until the expected device is
found.
5: Next, tap '
' next to 'Occupancy Settings'.
Select the site
Select
the area
Select the device
If needed, use 'identify' to
locate the correct device
' to place the device in the identify mode to
' prior to 15 seconds expiring to cancel
Select 'Occupancy...'
Tap 'Occupancy
Settings >'
www.cooperlighting.com
125
Advertisement
Table of Contents
