Create A Network Area Custom Template - Cooper WaveLinx Lite User And Programming Manual

Table of Contents

User Manual: WaveLinx Lite (4.0)

Templates can be created from the WaveLinx Lite Mobile App's menu (recommended method) or through the process of completing the 'Add

Site' wizard.

The steps in this section describe using the menu option to create templates although the steps for either option will be similar. The user does

not need a Bluetooth connection to WaveLinx devices or to the internet to create a custom template, although an internet connection will be

necessary to sync the template to the cloud. If needed, the template sync can be performed later when an internet connection is available.

Create a Network Area Custom Template

Templates for a networked area allow customization of:

• Zones: Define the quantity of zones, the high-end and low-end trim for the zone, and the default dim level (10% is typical).

• Occupancy Sets: Define the number of occupancy sets needed in the area, assign the zone(s) to the occupancy set(s), change occupancy

set mode (occupancy/vacancy), hold time and each assigned zone's response for occupied, energy saver (dimmable zones only) and

unoccupied levels/states.

• Scenes: Define the light level that each zone should assume when scenes commands are used.

To create a custom template for a network area:

1: Launch the WaveLinx Lite Mobile Application from the app icon.

2: Tap the menu '

', and then select 'Templates'.

3: If this is the first custom template, tap 'Add A Template', otherwise tap ' ' to add a new template.

4: Type a unique descriptive name for the template that will allow for easy identification later and then tap 'Networked'. The template name

must be different from other template names created by that registered user.

Tap 'menu'

Select 'Templates'

Add Site

Tap '

' or 'Add a Template'

Unique descriptive name

Select 'Networked'

www.cooperlighting.com

Table of Contents