Modify Devices In Networked Areas; Rename Devices - Cooper WaveLinx Lite User And Programming Manual

User Manual: WaveLinx Lite (4.0)

Modify Devices in Networked Areas

After devices are provisioned, it is possible to change the device name. Devices may also be deleted, returning them to an unprovisioned state.
For details on moving a device to a different zone, refer to page 83. Internet connection is not needed to modify a device but connection to the
WaveLinx Lite device/network is required.

Rename Devices

Optionally devices may be given a more descriptive name to help with identifying the device location or function.
To change a device name:
1: Bring the mobile device within range (within 60 feet) of any line voltage powered provisioned WaveLinx Lite device in the desired area.
2: Ensure that the mobile device Bluetooth is turned on, and then open the WaveLinx Lite Mobile Application.
3: In the site list, select a site.
4: In the area list, select the desired area. After a short delay, verify that the area shows that the mobile application is connected to the network.
Tap on the icon if it is necessary to refresh the connection.
5: If the device is a wallstation, scroll down to the 'Devices in Area' section. If the device is a control device (light fixtures with a fixture mount or
integrated sensor, for example), in the zone list, select the zone that the device is assigned to.
Select the site
6: In the listed devices, locate the desired device. If needed, use the identify icon '
found (battery powered devices will not respond to an identify command).
7. Tap the device to open the device and then tap edit '
Note: Battery powered wallstations will request that a button be pressed. Once the wallstations is awake, tap 'Confirm' to proceed.
Wallstation
Tap device
If needed, use 'identify' to
locate the correct device
(only line voltage devices)
Select the area
' to change the device a new name. Tap 'Save'.
Battery powered
wallstations: Press any
button then tap 'Confirm'
Tap device
Select edit
Verify network
connection
Select the zone
the device is
assigned to
OR
Locate the device
in 'Devices in
Area'
' to place a device in identify mode until the correct device is
Fixture Mount or Integrated Sensor
If needed, use 'identify' to
locate the correct device
Not connected
Connected
Enter desired name
Tap 'Save'
Select edit
www.cooperlighting.com
85