Table of Contents
Advertisement
User Manual: WaveLinx Lite (4.0)
Use Screen Controls to Issue Commands and View Details
The site administrator can use the WaveLinx Lite Mobile Application to issue real-time lighting commands and view details and status. Some of
these commands may only be appropriate for networked areas while others will be used in both standalone and networked areas. This section
will discuss the use of the mobile application to:
• Raise and lower the light level of a networked area
• Raise and lower the light level of a zone in a networked area
• Issue scene commands in a networked area
• Raise and lower the light level of a single device in any area
• View status and device details in any area
Internet connection is not needed for these commands but connection to the WaveLinx Lite device/network is required.
Raise and Lower the Light Level of a Networked Area
To raise and lower the light level of all devices in an area:
1: Bring the mobile device within range (within 60 feet) of any line voltage powered provisioned WaveLinx Lite device in the desired area.
2: Ensure that the mobile device Bluetooth is turned on, and then open the WaveLinx Lite Mobile Application.
3: In the site list, select a site.
4: In the area list, select the desired area, and verify that the network is connected.
5: Use the raise ' ' and lower ' ' controls to adjust the light level for all zones:
• Single tap: Light level will raise/lower in 1% increments.
• Press and hold: Light level will raise/lower faster (4% every 250ms) until finger is removed from the control.
Select the site
Note: The reported light level at the zone level will not reflect adjusted light level when area raise and lower commands are used.
Select the area
Not connected
Connected
Verify network
connection
Use the area raise
and lower controls
www.cooperlighting.com
135
Advertisement
Table of Contents
