Table of Contents
Advertisement
User Manual: WaveLinx Lite (4.0)
Add an Area
For step to add a new area, refer to "Step 2: Create Areas" on page 58.
Delete an Area
Internet connection or connection to the WaveLinx Lite device/network is not required to delete an empty area. An area can be deleted ONLY if
there are no provisioned devices in the area. The mobile application will block the deletion if the area still contains provisioned devices.
To delete an area:
1: Open the WaveLinx Lite Mobile Application.
2: In the site list, select a site.
3: In the area list or in an area's screen, select the delete icon ' '.
4: When prompted, tap 'Delete' again. The area will be removed.
Select the site
Modify Zones in Networked Areas
After zones are created it is possible to change the zone name and update zone operation parameters. Devices may also be moved between
zones and zones can be deleted.
Internet connection is not needed to modify zones but connection to the WaveLinx Lite device/network is required.
Rename Zones and Update Operation Parameters
The zone name and the operation parameters, i.e., minimum and maximum levels, can be changed after the initial setup with the exception of
the zone type.
• Zone name: Enter a unique name for the zone. Zone names must be unique within the area.
• Zone type: (Zone type cannot be changed after zone is created. The zone must be deleted and recreated if the zone type needs to be
changed). The zone type determines the options and behavior for the zone. For dimmable devices, select 'Dimmable' control. For relays or
lighting loads without dimming capability, select 'Non Dimmable' control. For devices controlling plug loads, select 'Receptacle'. Both 'Non
Dimmable' and 'Receptacle' zone types follow first ON, last OFF functionality (command @ 1% to 100% = ON, command @ 0% = OFF).
• Dim Level: (dimmable zone type only) The light level that a newly provisioned device should go to when it is added to the zone. A low level
(default 10%) is recommended. When a device is provisioned and assigned to this zone, it will dim to the defined level along with other
devices in the zone. Unprovisioned devices will be ON to 100% if there is occupancy in the area, allowing for easy identification of
unprovisioned vs. provisioned devices
• Minimum level (low end trim): (dimmable zone type only) The default setting is 0%. Sets the lowest level that dimming commands can set
the dimmable light level to. Typically used to provide a desired aesthetic. Regardless of the minimum level set, a 0% command will turn the
load OFF.
• Maximum level (high end trim): The default setting is 100%. For dimmable zones, this sets the highest level that the dimming command
can set the dimmable light level to. Typically used to save energy or to provide a desired aesthetic. For non-dimmable or receptacle zone
types, the maximum level can be adjusted to set the desired ON level if dimmable light sources are assigned to the zone. When an ON
command is received, the light source will be commanded ON to the maximum level set.
Select the
delete icon
www.cooperlighting.com
Confirm
delete icon
81
Advertisement
Table of Contents
