Raise And Lower The Light Level Of A Zone In A Networked Area - Cooper WaveLinx Lite User And Programming Manual

Table of Contents

Raise and Lower the Light Level of a Zone in a Networked Area

To raise and lower the light level of a specific zone:

1: Bring the mobile device within range (within 60 feet) of any line voltage powered provisioned WaveLinx Lite device in the desired area.

2: Ensure that the mobile device Bluetooth is turned on, and then open the WaveLinx Lite Mobile Application.

3: In the site list, select a site.

4: In the area list, select the desired area, and verify that the network is connected.

5: In the zone list, select the desired zone.

6: Use the zone slider or level entry field to adjust any dimmable zone to the desired light level.

use the ON/OFF toggle to adjust the desired state.

The reported light level of the zone slider may not reflect current light level if device light level has been adjusted by area raise and lower commands or by other devices that

do not issue zone commands.

The slider will display the full 0-100% scale and will not reflect adjustments to the minimum level (low end trim) or maximum level (high end trim) for the zone. The zone will

stop changing when the slider reaches the defined minimum or maximum level and will stay at that level if the slider is moved beyond the defined range, until the slider is

moved back into the defined range. The exception is that a slider level of 0% will turn the zone OFF regardless of minimum level (low end trim) setting.

Adjusting the slider at the zone level will rewrite the zone's default 'Dim Level' to the new level selected. Any new devices that are newly provisioned to the area will go to the

zone's new dim level value.

136

www.cooperlighting.com

Select the site

Select the area

For non-dimmable or receptacle zones,

89 90 91

Not connected

Connected

Verify network

connection

Select a zone