Figure 8-4 Removing The Filler Panel - Sun Microsystems Sun Blade 1000 Service Manual

4. Attach the antistatic wrist strap.
See Section 5.7, "Attaching the Antistatic Wrist Strap" on page 5-10.
5. Remove torque tool A or torque tool B from its holder.
See Section 8.2, "Removing a Torque Tool" on page 8-4.
Note – Sun manufacturing installs torque tool A or torque tool B in Sun Blade 1000
and Sun Blade 2000 workstations. The torque tools are located in different locations
in the workstation.
6. If necessary, remove the filler panel (see
Squeeze the two tabs on the filler panel to release it from the cover for the CPU
shroud.
Tab(2)
Removing the Filler Panel
FIGURE 8-4
Chapter 8 Removing and Replacing the Motherboard and Associated Components
).
FIGURE 8-4
Filler panel
Cover for the
CPU shroud
Shroud
8-7