1.7.2
Removing the CD-ROM Drive and Tape Drive
1. Remove the seven screws holding the access panel to the SCSI tray (
2. Release the data and power cables from the rear of each device by reaching
through the access panel.
3. Release the device enclosure from the SCSI tray by removing three screws on the
left-hand side. Pull the device enclosure out from the SCSI tray (
FIGURE 1-15
4. Remove the CD-ROM drive by removing the four screws securing the drive to the
device enclosure, two at the top and two at the bottom (
the drive free of the enclosure (
1-16
Sun Enterprise 5000 Centerplane Upgrade Guide • March 1999
CD-ROM
drive
Removing the SCSI Tray Access Panel and Device Enclosure
Access
panel
).
FIGURE 1-16
FIGURE 1-15
).
FIGURE 1-15
Device
enclosure
) and then pull
FIGURE 1-15
).