C.1.8.3
Graphics and PCI Card Options
For maximum system performance, the following graphics cards and all 33 MHz PCI
options must be installed in PCI card slot 2, 3, or 4 on PCI Bus B (33 MHz Bus):
Sun Expert3D
Sun Expert3D-Lite
Sun PGX64
SunATM/P 155 MMF adapter
SunATM/P 155 UTP5 adapter
SunATM/P 622 MMF adapter
Note – Installing a 33 MHz card into a 66 MHz extended peripheral component
interconnect (EPCI) slot J2301 decreases system performance.
C.1.8.4
Sun Expert3D and Expert3D-Lite Graphics Cards
A software patch is required when two Sun Expert3D or Expert3D-Lite graphics
cards are installed in a Sun Blade 1000 or Sun Blade 2000 workstation. This software
patch prevents system lockup of the CPUs when processing data between two
Expert3D or Expert3D-Lite graphics cards. The software patch number is 108576-08
and is downloaded when you install the Sun Expert3D or Expert3D-Lite software
provided with the graphics card installation kit. Check for the latest patch level by
going to the following Sun web site:
http://www.sun.com/sunsolve/
C.1.9
Peripherals
The following peripherals are supported by the Sun Blade 1000 and Sun Blade 2000
workstation:
Section C.1.9.1, "DVD-ROM and Tape Drives" on page C-29
Section C.1.9.2, "Diskette Drive" on page C-30
Section C.1.9.3, "Hard Drives" on page C-30
Section C.1.9.4, "Smart Card Reader" on page C-31
C.1.9.1
DVD-ROM and Tape Drives
The DVD-ROM, and back-up devices (tape drive) are interfaced through a SCSI
controller. The Sun Blade 1000 and Sun Blade 2000 workstations use a SCSI host
controller on the PCI bus. This controller is used only in fast narrow mode.
Appendix C Functional Description
C-29