Sun Microsystems Sun Blade 1000 Service Manual page 120

CODE EXAMPLE 4-7
Decompressing Done
Size = 0000.0000.0006.da00
ttya initialized
Start Reason: Soft Reset
System Reset: (SPOR)
Probing gptwo at 0,0 SUNW,UltraSPARC III (400 MHz @ 4:1, 4 MB)
memory controller
Probing gptwo at 1,0 Nothing there
Probing gptwo at 8,0 pci pci upa ppm
Loading Support Packages: kbd-translator
Loading onboard drivers: ebus flashprom bbc ppm i2c dimm dimm dimm
dimm
nvram idprom i2c cpu sensor fan-control card-reader motherboard
beep
Memory Configuration:
Segment @ Base:
Can't read mem-layout table from sys SEEPROM.
WARNING: HOSTID data should be moved to socketed SEEPROM!
HW support required for hostid reprogramming!
Probing /upa@8,480000 Device 0,0 Nothing there
Probing /upa@8,480000 Device 1,0 Nothing there
Probing /pci@8,600000 Device 4
Probing /pci@8,600000 Device 1
Probing /pci@8,700000 Device 5
Probing /pci@8,700000 Device 6
Probing /pci@8,700000 Device 1
Probing /pci@8,700000 Device 2
Probing /pci@8,700000 Device 3
Probing /pci@8,700000 Device 4
(UltraSPARC III), No Keyboard
OpenBoot 4.0 common-23, 512 MB memory installed, Serial #8839885.
Ethernet address 8:0:20:86:e2:cd, Host ID: 8086e2cd.
6. At the ok prompt, type
(
CODE EXAMPLE 4-8
4-16 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
Reset All
audio rtc gpio pmc floppy parallel serial
obdiag
).
0 Size: 512 MB ( 2-Way)
scsi disk
Nothing there
network firewire usb
scsi disk tape scsi disk tape
Nothing there
Nothing there
Nothing there
Nothing there
. Verify that the OBDiag menu is displayed
Using default!