Motherboard - Sun Microsystems Sun Blade 1000 Service Manual

2. Install the graphics card.
See Section 8.4.4, "Replacing the Graphics Card" on page 8-26.
3. Install the CPU shroud cover.
See Section 8.9.2, "Replacing the CPU Shroud" on page 8-41.
4. Detach the antistatic wrist strap, replace the access panel, and power on the
workstation.
See Chapter 9.
5. Reset the time of day and date.
If necessary, at the system prompt type: date [-u] mmddHHMM[[cc]yy][.SS]
8.8

Motherboard

Perform the following procedures to remove and replace the motherboard. If
necessary, view the ShowMe How video clip located on the Sun Blade 1000 and Sun
Blade 2000 Hardware Documentation CD-ROM.
Caution – Use an antistatic mat when working with the motherboard. An antistatic
mat contains the cushioning needed to protect the underside components, to prevent
motherboard flexing, and to provide antistatic protection.
Note – If you are replacing the motherboard, remove the audio module, graphics
card(s), CPU module(s), and PCI card(s) prior to removing the motherboard. Note
the chassis connector location for each graphics card and PCI card prior to removal.
Note – The workstation ID SEEPROM contains the system host identification (ID)
and Ethernet address. If the same ID and Ethernet address are to be used on the
replacement motherboard, remove the workstation ID SEEPROM from the
motherboard and install the removed workstation ID SEEPROM on the replacement
motherboard after motherboard installation. See
Chapter 8 Removing and Replacing the Motherboard and Associated Components
.
FIGURE C-15
8-35