Replacing The Diskette Drive; Replacing The Peripheral Assembly - Sun Microsystems Sun Blade 1000 Service Manual

7.2.9

Replacing the Diskette Drive

Note – If you are installing a diskette drive (instead of replacing it), ensure that the
peripheral power cable and all data cables are properly routed through the clips
adjacent to the drive bay.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
1. Remove the filler panel if necessary (
2. Remove the smart card reader if it has been installed.
See Section 7.2.6, "Removing the Smart Card Reader" on page 7-7.
3. Position the diskette drive in the peripheral assembly.
4. Using a No. 2 Phillips screwdriver, replace the four screws securing the diskette
drive to the peripheral assembly.
5. Replace the smart card reader.
See Section 7.2.7, "Replacing the Smart Card Reader" on page 7-8.
6. Replace the peripheral assembly.
See Section 7.2.10, "Replacing the Peripheral Assembly" on page 7-10.
7.2.10

Replacing the Peripheral Assembly

Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
1. Position the peripheral assembly in the chassis (see
Note – Ensure that the peripheral assembly is correctly seated in the rails of the
chassis.
2. Connect the rear cable connectors to the drives as required.
7-10 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
).
FIGURE 7-3
FIGURE 7-2
).