Sun Microsystems Sun Blade 1000 Service Manual page 16

Removing and Replacing the Logo LED Cable Assembly 6-18
FIGURE 6-11
Removing and Replacing the Interlock Switch Assembly 6-20
FIGURE 6-12
Removing and Replacing a Fan Assembly 6-22
FIGURE 6-13
Removing and Replacing the Fan Bracket 6-24
FIGURE 6-14
Removing and Replacing the Speaker Assembly 6-26
FIGURE 6-15
Removing and Replacing the FC-AL Backplane Assembly 6-28
FIGURE 6-16
Removing and Replacing the Chassis Foot 6-30
FIGURE 6-17
Removing and Replacing Plastic Filler Panels 6-31
FIGURE 6-18
Removing and Replacing Metal Filler Panels 6-32
FIGURE 6-19
Removing and Replacing a Hard Drive 7-2
FIGURE 7-1
Removing and Replacing the Peripheral Assembly 7-4
FIGURE 7-2
Removing and Replacing the DVD-ROM Drive 7-5
FIGURE 7-3
Removing and Replacing the Smart Card Reader 7-8
FIGURE 7-4
Removing and Replacing the Diskette Drive 7-9
FIGURE 7-5
UltraSPARC III Cu CPU Module and Label 8-2
FIGURE 8-1
Location of CPU Processor Slots 0 and 1, Captive Screws, and Torque Tools 8-4
FIGURE 8-2
Location of Torque Tool A and Torque Tool B 8-5
FIGURE 8-3
Removing the Filler Panel 8-7
FIGURE 8-4
Using Torque Tool A to Remove a CPU Module 8-8
FIGURE 8-5
Removing the Cover for the Shroud 8-10
FIGURE 8-6
Using Torque Tool B to Remove a CPU Module 8-11
FIGURE 8-7
Removing the Plastic Cover From the CPU Module Connectors 8-13
FIGURE 8-8
Lowering the CPU Module Into the Threaded Inserts 8-14
FIGURE 8-9
Alternately Rotating Left and Right Captive Screws One Turn Clockwise 8-15
FIGURE 8-10
Adjusting Captive Screws Until the Torque Tool Gap Is 0.0 Inches (0.0 MM.) 8-16
FIGURE 8-11
Installing the Cover for the Shroud 8-17
FIGURE 8-12
Alternately Rotating Left and Right Captive Screws One Turn Clockwise 8-18
FIGURE 8-13
Torque Tool A Clicks When the Captive Screws Are Correctly Torqued 8-19
FIGURE 8-14
Removing and Replacing a PCI Card 8-21
FIGURE 8-15
Graphics, EPCI, and PCI Card Slots 8-24
FIGURE 8-16
xvi Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002