Disabling The Existing Blade Prior To Removal; Removing The Existing Blade Or Filler Panel - Sun Microsystems Sun Fire B1600 Administration Manual

12.1.1

Disabling the Existing Blade Prior to Removal

G
To shutdown the blade in preparation for removal, and to cause the blue "Ready
to Remove" LED to be lit, type:
sc> removefru sn
Where
Note – If the Solaris Operating environment is executing on the blade the System
Controller will cause it to shut down in an orderly manner before it powers it off.
12.1.2

Removing the Existing Blade or Filler Panel

The steps in this section refer to removal of a single-width blade. The same steps
apply when installing a double-width blade or filler panel.
1. If you are removing a blade, check that the blue "Ready to Remove" LED is lit.
Note – Do not remove the blade until the blue LED is lit.
2. Insert your finger in the pull recess located at the bottom front of the blade lever
and pull gently to disengage the locking mechanism (
is the number of the slot containing the blade you are removing.
n
Chapter 12 Replacing Optional Hardware Components
).
FIGURE 12-2
12-3