Displaying Mirrored Port Information - Nortel 8300 Troubleshooting Manual

7
Variable definitions
Variable
id
enable|disable
mirrored_port
mirroring_port
mode

Displaying mirrored port information

Use the following procedure to display information about mirrored ports
on the switch.
Procedure steps
Step
1
Copyright © 2007, Nortel Networks
.
Configuring and monitoring port mirroring using the NNCLI 57
To set the mirroring port, enter the following command:
port-mirroring <id> [mirror-port <slot/port>]
Action
To display information about mirrored ports on the switch, enter the
following command:
show port-mirroring
"Show port-mirroring" (page 58)
port-mirroring command.
Nortel Ethernet Routing Switch 8300
Troubleshooting
NN46200-704 01.01 Standard
4.0 29 October 2007
—End—
Value
The port-mirroring entry ID (1 to 383).
Enables or disables the specified port.
• enable enables a mirroring port
already created in the mirror-by-port
table.
• disable disables a mirroring port
already created in the mirror-by-port
table.
The default value is enable.
The port number of the mirrored port.
The port number of the mirroring port.
The mode can be either tx, rx, or both.
• tx mirrors transmit packets.
• rx mirrors receive packets.
• both mirrors both the transmit and
receive packets.
displays output from the show