Nortel 8300 Troubleshooting Manual page 150

150 Troubleshooting tools
Navigation
•
•
•
•
•
Enabling an auto-trace
Use the following procedure to enable the trace auto-enable feature.
Prerequisites
•
Procedure steps
Step
1
Variable definitions
Variable
auto-trace <enable|disable>
Adding a module
Use the following procedure to add a module to be traced by the trace
auto-enable feature.
Procedure steps
Step
1
Copyright © 2007, Nortel Networks
.
"Enabling an auto-trace" (page 150)
"Adding a module" (page 150)
"Removing a module" (page 151)
"Specifying the CPU utilization percentages" (page 151)
"Specifying the time to monitor CPU utilization" (page 152)
To enable the trace auto-enable feature, the trace auto-enable command
must be used in Privileged EXEC mode.
Action
To enable the trace auto-enable feature, enter the following
command:
trace auto-enable auto-trace enable
Action
To add module to be traced, enter the following command.
trace auto-enable add-module <modid> <level>
Nortel Ethernet Routing Switch 8300
Troubleshooting
NN46200-704 01.01 Standard
4.0 29 October 2007
—End—
Value
Enables or disables auto-trace. The
default value is disable.
—End—