Troubleshooting For No Rendezvous Point; Troubleshooting For No (*,G) And (S,G) In The Mroute Table - Nortel 8300 Troubleshooting Manual

Troubleshooting for no rendezvous point

Use the following procedure if the network does not designate an active
rendezvous point (RP).
Step
1
2
Variable definitions
Variable
GRPADDR
RP-ADDR
RP-PRIORITY

Troubleshooting for No (*,G) and (S,G) in the Mroute table

The issue is often caused by the unicast route not being reachable. Use the
following procedure to check the route.
Copyright © 2007, Nortel Networks
.
Action
To display the active RP, use the following command: show ip
pim active-rp
"Show ip pim active-rp command output" (page 41)
output for the show ip pim active-rp command.
Show ip pim active-rp command output
Check the route to the RP.
Nortel Ethernet Routing Switch 8300
Troubleshooting
NN46200-704 01.01 Standard
4.0 29 October 2007
Troubleshooting PIM-SM issues in the CLI 41
—End—
Definition
Specifies the IP address of the multicast group.
Together with the group mask, the group address
identifies the prefix that the local router uses to
advertise as a C-RP.
Specifies the IP address of the C-RP. This
address must be one of the local PIM-SM
enabled interfaces.
Specifies the priority of the RP. C-RPs must send
C-RP advertising messages with the field set to
0, which is the highest priority.
shows sample