Nortel 8300 Troubleshooting Manual page 142

142 Troubleshooting tools
Procedure steps
Step
1
Deleting the ping snoop filter
Use the following procedure to removed the ping snoop filter from all ports
or a specified port.
Procedure steps
Step
1
2
Variable definitions
Variable
<ports>
Job aid: CLI configuration example of configuring ping snoop
This configuration example uses the previous commands and shows a
summary of the results using the info command.
Passport-8300:3/config/diag/ping-snoop# create src-ip
default
dst-ip default
Copyright © 2007, Nortel Networks
.
Action
To display the ping snoop filter and the ports on which it is applied,
enter the following command:
config diag ping-snoop info
Action
To delete the ping snoop filter on a particular port, enter the following
command:
config diag ping-snoop remove-ports <ports>
To remove the ping snoop filter from any ports that were added and
delete the filter, enter the following command:
config diag ping-snoop delete
Nortel Ethernet Routing Switch 8300
Troubleshooting
NN46200-704 01.01 Standard
4.0 29 October 2007
—End—
—End—
Value
<ports> specifies the port or range of ports in
the format slot/port[-slot/port][,...]
when you apply the ping snoop filter.