To configure and enable VCT, use the following command:
Passport-8310:5# vct test 2/9
Figure 11 "vct test command output" (page 109)
configured on port 2/9.
Figure 11
vct test command output
To display VCT information on slot 2, port 9, use the following command:
Passport-8310:5(config)# show vct 2/9
Figure 12 "Show vct command output" (page 109)
for this command.
Figure 12
Show vct command output
Example 2: Configuring VCT from Interface Configuration Mode
Copyright © 2007, Nortel Networks
.
Nortel Ethernet Routing Switch 8300
Troubleshooting
NN46200-704 01.01 Standard
4.0 29 October 2007
Using the Virtual Cable Tester 109
shows a VCT test
shows sample output